Übersetzung für "Nach oben biegen" in Englisch

Push up your eyelashes to curl them.

This is because the right foot will not bend upward enough.

Put a blank right angles upwards, bend slightly lower angle.

Pry up retaining clip and pull off connector (flathead).

Lay the rear panel face up and bend the top valve.

Lower corner (one layer) bend upward.

Now bend the flaps on the bottom side of the hat to the top and apply glue.

Young branches naturally grow upwards and only bend over time.

Go to the top, make a turn and weave in the other direction.

So the point of all this for us today is not just hopefully honesty for the sake of honesty, but a hope that by being more honest and candid about these experiences, that we can all collectively bend that happiness baseline up a little bit.

And so the final question that we would ask is: can we collectively bend that happiness chart upwards?

The tractions decrease in the event of an air pocket, and hence the ends of the reinforcing braces 64 will bend upward.

In this context, it is known in the field that during an accident, such T-shaped fittings can deform by bending upwards into a U-shape so that the opening lever of the belt buckle, which, according to regulations of the racing sport organization FIA, must point in downward direction, is now substantially hindered in its free motion so that the belt buckle can no longer be opened.

The material of the piston 16, preferably a plastic material, and the thickness of the flexible zones 60 are selected in such a way that the flexible zones 60 can bend upwards if pressure is exerted on material lying underneath.

The connector design of the present invention provides that the contact elements, which are bent from sheet metal into a tubular or groove shape, in partial zones, bend upwards from a common base zone.

In roller bending, the shank 47 previously could be bent upwardly, obliquely curved corresponding to the force 45, which is now avoided, since by means of the pressing roll process, uniform stretches arise, whereby re-formings are equalized.

In case of the present invention, contrary to the prior art, metal sheet material with the initial sheet material thickness is deformed when bending-up at the position of radius R 2 with the method according to the invention, wherein there is practically no spring back effect and a permanent tension of the peel-off foil can be reached.

At the last vegetable garden (on the left), turn right onto a paved road that goes up, turn after a barn (turn right: the Blanchampagne farm, formerly owned by the abbey of Orval).

Raising up or bending up respectively directly after the flanged rim or the slope of the flanged rim, as it is the result in case of the prior art mentioned at the beginning, is thereby avoided.

This prior art method doesn't lead to a sufficient tension of the peel-off foil because spring back effect in this area is very high after the bending up step.

By the upper bottom flap 12 being torn at the incision 17 as far as the folding line 13 at which the bottom flap 12 is connected to large sidewalls of the cylindrical casing wall 1, a portion 12 ? of the bottom flap 12 can be bent upward about the folding line 13 .

The middle region of the corner tuck 11 can then be bent upward about a folding line 23, as illustrated in FIG. 5 .