Übersetzung für "Dielectric breakdown" in Deutsch

The dielectric breakdown strength of such ceramics is 800 V/mm.

The dielectric breakdown strength was 190 kV/mm.

The dielectric breakdown voltage is an important quality criterion for the electrical insulating film.

This is due to dielectric breakdown and is irreversible.

That can prevent the formation of weak points where a dielectric breakdown can occur.

The “treeing” channels can result in dielectric breakdown through the main insulation.

The particles may also become attached to the post insulators and cause dielectric breakdown along a post insulator surface.

The average voltage gradient at which dielectric failure or breakdown occurs under prescribed conditions.

In order to increase the dielectric breakdown resistance and in order to improve the mechanical protection, a further protective layer 9 which may consist for example of rubber or of another protective lacquer can be applied to the vapor deposited silicon layer 8.

In order to avoid defects in the insulation, such as pin holes, and to avoid dielectric breakdown, it is known to increase the thickness of the insulator covering portions of the first polysilicon layer (including the critical sidewall).

In the case of electronic applications these surface damages cause reduced yields, increased shorts, non-uniformity in electrical properties and variations in dielectric breakdown thresholds.

This resistor does not acquire its properties as a voltage-dependent module until a semiconducting channel has been formed by dielectric breakdown in the resistor body after a voltage has been applied.

The voltage depends on the length of the bolt, with the dielectric breakdown of air being three million volts per meter, and lightning bolts often being several hundred meters long.

On the other hand, the dielectric loss factor increases sharply as the heating of the material caused by the absorption of energy in the high-frequency field increases, resulting in a significant drop in the breakdown voltage or dielectric strength and an increased risk of dielectric breakdown.

These coatings additionally have the advantage of, as dielectric, effectively limiting the electric current flowing during gas discharge, thereby offering protection against dielectric breakdown.

These compounds are usually employed in a quantity of up to about 1% by weight, preferably up to about 0.5% by weight, in the film, and lead to a reduction in oxidation phenomena and hence to improved constancy in time of the dielectric loss factor and the dielectric breakdown strength of the film when used in a wound capacitor.

The combination of excellent strength and high density also would be advantageous for wrapping electric conductors, the dielectric breakdown strength increasing along with the density.

It is moreover possible in case of in-situ monitoring of the transmission field (H or E field) to interrupt transmission or clip the power of the transmission pulse when the maximum power is exceeded and the voltages in the oscillating circuit reach a level at which a dielectric breakdown or burn out of a critical component is to be feared.

Method according to claim 1, wherein in addition, the acoustic signal arising on dielectric breakdown is picked up and evaluated.

Such structures are susceptible to destruction by a dielectric breakdown of the insulation layer, caused by electrostatic charging.

The converters have an output voltage of +6V which is ideal to efficiently switch GaN HEMTs (High Electron Mobility Tranistors) without causing a gate dielectric breakdown.

During the impact of the discharge there occurs a dielectric breakdown, therefore to the conduction of power relatively quickly down to the underground, without further spreading on the ground.