Übersetzung für "Tangential stress" in Deutsch

In most cases, there is a two-dimensional tangential stress.

Sprags as well as the rings are loaded in the contact area by tangential and radial stress.

With this construction, it is prevented that the casing in addition to a tangential stress is also subjected to an axial stress.

Proportionality between the pressure difference and the radial or tangential stress alone is not given.

Finally, the nails are, on forcibly driving the nails, guided at the driving-in position by the guiding channel of the insert member, so that also when driving-in the nails there exists no danger of injuring the bone by subjecting the proximal cortex to tangential shearing stress.

The yield value assured hereinafter is defined as the smallest force per unit area (shear stress, tangential stress) which is required to cause a flow.

The yield value assured hereinafter is define as the smallest force per unit area (shear stress, tangential stress) which is required to cause flow.

The level of maximum tensile stress and the values of the tangential tensile stress occurring during the subsequent operating temperature govern the crack sensitivity of the wire seals during cooling and during use.

But also when forcibly driving the nails, a cortical wedge can be split off the proximal cortex by the tangential shearing stress, which results to an undesired enlargement of the impact hole, noting that the edge of the impact hole can also collapse at the forward side.

This permits the assumption that the total stress which acts in the TBC layer tangentially to the surface of the member is determined by the total tangential stress of the base material.

Outside the circular arrangement, in the vicinity of each diaphragm, there are arranged four resistance elements, that is to say in a position where the largest difference occurs between the tangential mechanical stress and the radial mechanical stress.

Here, the peripheral stress—which is partially also referred to as the tangential stress—acts in an axial cross section of the measuring tube wall, whereas the axial stress acts in a radial cross section of the tube wall.

The tangential stress 15 and radial stresses 16 occurring during operation of the asynchronous motor are—as also in the following figures—identified by arrows in this section of the rotor 5 .

The stresses that occur during reshaping, in particular the radial tension stress and the tangential compressive stress, result in a particularly complex flow of material.

The measuring ring is clamped onto the tension body, in particular with a predefined tangential stress, in order to obtain particularly reliable measured values.

The measuring ring 11 is advantageously clamped onto the tension body with a predefined tangential stress in order to obtain particularly reliable measured values.

The tangential stress necessary for bulging is consequently relatively low and the divergence 39 from the ideal circular shape is relatively large.

As a result of the conicity of the arrangement of the rolling members 11 in the forming device 10, a centering of the blank 18 and a uniform material filling of the teeth is obtained and a tangential compressive stress and an axial tensile stress is produced in the workplace surface.