Übersetzung für "Static current" in Deutsch

MOS inputs require no static current to be activated but are voltage-controlled.

In addition, the static current distribution is improved, as in the known circuits where separate current distribution chokes are used.

The area identified by reference numeral 300 indicates static pump current lp.

This means that a resulting static read current flows on the respective bit lines.

The magnitude of the static read current that occurs represents the logic levels of the memory occupancy.

The fuse can serve at least partially (if not entirely) to balance the static current distribution.

Ground yourself to prevent damage to the internal parts of the device due to static current.

Compared to non-static elements only current in transactions, the static data elements are markedly longer-lived in terms of time.

The parameter's transition from its previous value to the current static value is displayed as two segments:

Parameter transition from its previous value to the current static value is displayed as two segments:

This includes performance data such as volume flow, static pressure, nominal current of the motor and running time.

He raised the question as to whether the current static legalistic approach should be maintained or whether the integration in various areas of the single market should be more flexible – i.e. by leaving more space to the stakeholders and free market in some areas and, in others, by going more deeply into the matter and introducing detailed legislation.

However, a conventional current source with a static current-voltage characteristic can also be employed as a constant current source, in which case an electronic switch with a shunt should be provided for the switch from the maximum to the minimum output current.

When the maximum power output of the switch controller SR defined in such fashion is reached and possibly exceeded, then the input voltage U1 of the circuit arrangement is reduced and a static current limitation is not required.

However, the regulating stage only adjusts the static current of one branch of the push-pull end stage, namely the branch having the transistor 3.

The quarter-bridge circuit as claimed in claim 1, wherein in order to balance the static current distribution in the parallel current paths a resistor is provided, in series in each case, which is preferably at least partially formed by a fuse.

Present tristate bus architecture requires low impedance, high current drivers due to high stray bus capacitance, high data rate transfer requirements and high DC static receiver current.

In the static condition, the current having a very specific current intensity also flows between these points of incidence of the two electron probes.

The switching device ER is bistable and reacts to reversals of polarity of the loop current in the loop circuit of the exchange line AL-FS, which in the static state as a result of the resistance R is hign-ohm and is acted upon with a static current of pregiven direction, as a result of which the switches 1er to 4er are open, whereas switch 5er is closed (as shown in FIG. 2).