Übersetzung für "Operation error" in Deutsch

Training topics include: installation, operation, maintenance and error diagnosis.

Also, any unintentional operation or error in the operation of the control devices has to be avoided.

If an error occurs in one calibration operation, this error is of only minor significance.

They are characterized by smooth operation, small error, very low running noise and high running speed.

In this case, B_x is the expected value, i.e., the value of the modulo operation in the error-free case.

What should we do if operation error after installing client?

16.What should we do if operation error after installing client?

Emergency operation for this error can provide the following assignment between bit patterns and switch functions:

If a type is incompatible with the requirement of an operation, an error is reported.

The length of the program module X of the program PP2 from the synchronisation instant to the entry of the sum codeword C2 of the first conference K1 is determined such that the processor P1 has definitely generated and transferred the codeword C2 provided that the operation is performed error-free.

The second periodic operation-dependent error which likewise occurs repetitively in each fifth frame is due to variations in the film channel between the film transport sprocket and the film pressure pd during a revolution, caused by out-of-roundnesses and eccentricities of the motor shaft and film transport sprocket, and is influenced by the type of film (thin or thick film, stiff or flexible film), wear phenomena on the film transport sprocket, film channel, and motor bearings, contamination of the angle indicator disk, etc.

By means of the novel, simple circuit, the various parts of which (including the driver transistors and the diodes of the control logic, the ring counter, and the logic circuit elements) can be realized in integrated technology, a reliably operating circuit arrangement is obtained for the continual operation monitoring and error diagnosis of a stepper motor controlled at its windings by means of a control logic and driver stages, using stepping pulses which are phase-shifted relative to each other.

Economically mass-produced yaw rate sensors which can be used in motor vehicles are based, for example, on the principle of measurement of the influence of the Coriolis force on a vibrating ceramic structure (Fox, C. H. J.: Vibrating Cylinder Gyro--Theory of Operation and Error Analysis.

All entered and measured data can be controlled by a representation on the monitor 38 so that an error-free operation or error-free machining is ensured.

The second memory areas 2 are used only in the first mode of operation to store error correction data assigned to the useful data stored in the first memory areas 1 .

The second memory area is used in the first, but not in the second, mode of operation to store error correction data for useful data which are to be stored in the first memory area.

Position sensor according to claim 6 wherein an error signal (?) for the new part is ascertained at a factory which is proportional to the measured error the the position sensor, the error signal (?) and a preset limit value are stored, and, during subsequent operation, a current error signal (? actual) is determined, and a check is run to determine whether the two error signals (?, ? actual) differ by more than the stored limit value, whereupon a warning signal is generated.

Then, during subsequent operation, a current error signal is determined and a check is made to determine whether the two error signals differ by more than the stored limit value, whereupon a warning signal will be generated.