Übersetzung für "Langes drücken" in Englisch

Long press the Home button down in the middle of your iPhone to initiate Siri.

Long press will activate the unique interactive live effects of each 3D theme.

Pressing for a long time can switch the radio off or on.

Long press the switch, the flashlight will enter Strobe-SOS mode.

By pressing this button for 10 seconds, you can also turn your programming board off.

Start marking them by long-pressing on one of them.

These functions can be selected by pressing or pressing and holding.

The commands can also be edited by a long press on the entry.

Then exit the setup mode by pressing the Done button again.

A long press leads to the selection of "Shutdown" or "Power Reserve".

One-button control, the LCD indicates the function for short, long or double press.

Activate your voice assistant on AndroidTM or iOS with a long press of your headphones.

If you are an Android user, you can use a long press to start the process.

Two can be sent using a programmable button by pressing or pressing and holding.

Light modes: Constant light or hidden emergency signal light (activated by long push of power button)

Improved handling of bookmark nicks, long press on ‘allow’ or ‘add back’ snackbar to bring up ‘reject’, made PEP avatars public to play nice with the newly released Prosody 0.11, OMEMO stability improvements.

After that, long press your device’s home button for a few seconds while connecting this to your system.

The TraceWeld system is controlled by one multifunction push button, where the long push would set the pipe size and the short push would start the welding cycle timing.

To do this, you will have to disconnect your iPhone from your computer and restart it by long-pressing on the lock button.

There is also a redesigned camera app that adds new features such as a scroll wheel for choosing between the different lenses and long-pressing the shutter button to take a video.

The controller can only be set after the remote control, this is always and under any condition the case, long press causes the shutdown.

You can also revert the system by pressing the red reset button on the back of the codec for 15 to 20 seconds.

Proceeding from a slice image 73 (see FIG. 17) obtained with the optimal setting of the parameter corresponding to the skin moisture, actuation of a corresponding switch, preferably by means of a prolonged pressing of the center foot switch 55 m (see FIG. 13), enables switching from the slice mode to the en-face mode, in which—as illustrated in FIG. 19 —the slice image 73 is displayed scaled-down (so-called thumbnail) in the right area of the monitor 70, and simultaneously an en-face image 76 that was acquired in the operating mode 2, the so-called en-face mode, is shown in the center area of the monitor 70 .

The flip-flop unit FF can be switched-off and reset, respectively, by continuous pushing of the momentary switch T 1 by a processor, if the momentary switch is held over a period of longer than about one or more seconds.