Übersetzung für "In geschlossener form" in Englisch

Of particular interest are solutions in closed form.

Equation (27) above cannot be solved in closed form.

Hence the aforementioned matrix P can be calculated in closed form.

However, the vault ribs may also be designed in a closed form with flat supports.

The container 1 is shown in a closed state.

FIG. 4A shows the sheet material repository 13 in locked condition.

To this end, the passports are placed in closed form into 10 loading units.

The system can be built as a closed design.

Various chain types in open or closed forms are used.

If the shaft is loaded only in torsion, then one of the principal stresses will be in tension and the other in compression.

A characteristic feature of this process is that the polyaddition reaction takes place in a closed mold.

They may be in open or closed form, in particular as open or closed multilayer tablets.

Jumprings are available in different sizes and wire diameter sizes, as well as open or closed jumprings.

Depending on the travel distances, various chain types in open or closed forms are used.

We share holding in the form of close-end Index funds in Chinese solar stocks which are listed in domestic and international market.

On the other hand, European political parties simply do not exist in any coherent form except in the minds of enthusiastic integrationists.

With these boundary conditions, the integrations yieldformula_22This is easily rewritten as an integral in closed form, although one that can only be solved numerically.

The strategy should combine existing and supplementary measures, to be implemented in an organic and coherent way so as to avoid overlaps that could lead to confusion over roles or to excessive cost increases for economic operators.

In the invention, a paint is chosen which dries to opacity; after leaving the spray gun, it gathers into droplets which deposit in the form of closed spots.

In each case, 6 g of this mixture is heated, as described in Example 3, in a closed mould for 12 minutes in an oven at 320° C. (maximum internal temperature of the mould is 300°).

By virtue of these inserts in closed or segmented form, expansion in the area of the piston ring strips is considerably diminished when the piston heats up.

Only with die casting, in a method that has been known for about 20 years--the body is formed in a closed mold by using slip under high pressure--was it possible to dispense with using plaster as a mold material.

It is of course directly possible subsequently also to apply inert coats of various types, either in the form of cohesive film or in the form of deposited powders, to the granules prepared according to the invention, but a particular advantage in the present invention is that such a measure can be dispensed with.

Since this is not possible in closed form, approximation solutions are given which, for one, fulfill the requirement for an exact vsb colour rendition and for the other are technically simple to handle as regards the circuitry.

Since the integral equation system describing this assignment cannot be solved in mathematically closed form according to the concentrations, approximation solutions must be found which, for one, fulfil to a large extent the requirement for exact vsb colour rendition and for the other, are technically easy to handle with respect to the circuitry.

Furthermore it is provided that the dirt-sensitive choke bore, generally used in servo-controlled valves, is produced by open channels, which bore is defined by the lip of a robust and temperature-insensitive groove and lip seal in the form of closed rectangles, the lip surrounding the core.

The reflectors used in this case are either in the form of closed surfaces of defined curvature and envelope or are laid out using gridlike arrangements of discrete conductive linear elements of defined length and spacing.