Übersetzung für "Load drop" in Deutsch

This flat load drop causes the rolls to be treated more gently and does not result in the undesired markings.

In the case of a ratio d A to d K that is less than 1.35, the possible load ratings drop.

Newer 'arc shields' (?) possess higher support resistance and also a lesser load drop during telescoping, at least for part of the yield travel.

For this purpose, the load current must drop below the holding current which necessarily occurs at the end of each positive half wave in the case of an operation with alternating current and, for which purpose, additional quenching circuits are necessary for a controlled current interruption.

Since the lamp acts roughly as resistive load, this drop in voltage is phase shifted by about 90° with respect to the lamp voltage.

All that has to be stated is that with increase in the output torque the control disk 25 is raised, and with decrease in the torque (load drop) there is a downward axial movement.

Its value is dimensioned such that at full load a voltage drop of 0.1 to 1 V, preferably 0.2 to 0.5 V, results.

As long as a current is flowing in the current path to the load, the voltage drop across the resistance is sufficiently great, and can be identified as a measured value and, for example, it is possible to use a comparator to test whether the measured value has the required magnitude, and a limit value has not been undershot.

In the same way, incorrect recognitions which would occur in case of a rapid load drop are eliminated, if the test variables which characterize the combustion take on smaller values with a delay, and the thresholds corresponding to the lesser load state would therefore be exceeded.

Since the arc path is in series with the load, the additional drop in voltage at the arc reduces the load current.

Switching on loads that entail a high input power, which includes vacuum cleaners, results in a load-dependent voltage drop.

It has surprisingly been found that the load ratings, which drop as the gel time is extended, are actually significantly improved by adding a co-accelerator, which by itself allows only very moderate load ratings.

Then good low-temperature curing is observed, but the load ratings of the compound cured in this way suffer, so that load ratings drop at high temperatures (+40° C.).

When the system switches over to high-performance capacitors 12, an acoustic siren 14 and warning lamp 15 are activated that indicate that the load may soon drop.