Übersetzung für "Hoher widerstand" in Englisch

It follows from this that there is a high inductive resistance "off" switching state.

Hence the thermistor presents a high resistance when the tertiary windings are connected.

For example, a high electrical resistance occurs in particular with printed conductive pastes.

In these cases, the material becomes a normal conductor and a high resistance occurs.

A high thermal resistance must be present in order to achieve the greatest possible voltage output.

High toughness and high resistance to crack propagation and diffusion are salient features.

Brass tube offers high resistance to moisture and it do not get rusted.

Great absorption and large resistance, even when it is wet.

Higher specific electrical resistance contributes to higher insulation resistance between the strain gauge and the component.

High resistance to pitting, crevice corrosion resistance.

Our Aqua Paddle Boat products made of high density, resistance to U.V.

The thicker coating offers good weathering resistance.

A very high resistance is offered the current flowing only through one winding, respectively.

In tests with 10% by weight of aluminum-plastic composite material as addition of scrap, a very high electrical resistance was determined.

In detail B, a short-circuit has occurred, there being a high resistance in this case.

This is advantageous metrologically since an undefined high resistance is difficult to detect during sensor operation.

In particular a high resistance to pitting corrosion and stress corrosion cracking is desirable, above all in chloride-containing media.

High resistance to high temperature also is better, can to 1000-1200 degrees.

Its high modulus of elasticity, thermal conductivity and electrical resistance are also of importance.

The Committee does, however, regard the general introduction of road pricing in urban areas as problematic because of (a) the high level of local opposition to this idea, (b) the attendant administrative costs, and (c) the danger that traffic will be transferred away from central urban areas to outside areas, thereby jeopardizing the viability of inner-city areas.

In the case of the heater according to the invention, low heat radiating capacity and high electric resistance in the adjacent portion cause the adjacent portion to heat-up considerably faster than in the known heater; during the first warm-up phase, they even cause the temperature in the adjacent portion to exceed the operating temperature, which is reached after some time.

In the case of the heater according to the invention, low heat radiating capacity and high electric resistance in the adjacent portion cause the adjacent portion to heat-up considerably faster than in the known heater; during the first warm-up phase, they even cause the temperature in the adjacent portion to exceed the operating temperature, which is reached after some time.

Pressing the circular ring shaped end edges of this device into human or animal tissue, particularly into muscle tissue is opposed by a high resistance which must be overcome by corresponding forces.

Since the resistivity of the liquid crystal mixture usually decreases by interaction with the inside surfaces of the displays over the lifetime of an MLC display, a high (initial) resistance is very important for achieving acceptable service lives.

Since the specific resistance of the liquid-crystal mixture generally decreases over the life of an MLC display due to interactions with the internal surfaces of the display, a high (initial) resistance is very important for displays which are required to have acceptable resistance values over a long service life.

The material for the coil conductor runs must be silver or a silver-palladium alloy, for instance, and a high ohmic resistance of the conductor runs must be tolerated.

Since, as is known, there is the danger of eddy current losses in inductive transmission systems, the nonmagnetic material surrounding the elements transmitting magnetic energy is selected and/or structured advantageously in such a way that a high electric resistance is present at least in a direction perpendicular to the acting magnetic lines of force.

This means that such a high resistance against rotation is now opposing the stator of the motor that it can not turn further so that, instead of the stator 324, the rotor 323 and thereby the drive shaft 304 of the motor now start to turn and the drive roller 1 is set into rotation by way of the corresponding gear connection and in its turn, in engagement with the bottom of the receptacle, drives this.