Übersetzung für "Warp direction" in Deutsch

With linear polarization, attenuation is measured parallel to the warp and weft direction.

The application also considers the use of a polyester yarn in the warp direction.

This direction is always called the warp direction in what follows.

The weft and warp direction are also important.

The measured aperture sizes are documented separately for warp and weft direction.

This could result in an undesirable displacement of the binder thread 110 in warp direction.

Consequently, all warp threads extend parallel in one warp thread direction.

The at least one flow groove preferably extends in warp yarn direction.

The specimens were sewn in double layer in warp direction as in a common sewing machine.

The pile density, measured in the warp direction, also remained clearly limited in this case.

The fabric must be stretched in the warp direction.

The float yarns preferably only run in the warp direction.

Both methods measure the wire cloth in warp and weft direction.

In the warp direction, polyamide fibers are used, improving the impact resistance of the carcass.

The surface resistance of this sample is 0.003 Ohm not only in the weft direction but also in the warp direction.

In this way, the group of picks is correspondingly displaced in the warp direction by the target full beat-up distance ADtarget.

The fixation of the filling system to the plies forming the multiply fabric is caused by binding threads extending in the warp direction.

In this way, a detection of defects can be made over a region extending along the warp thread direction.

The width of the recess 25 measured in warp yarn direction K may correspond to the width of the shaft projection 22 .

The distance between binding locations in the binding system may be selected so as to be different in warp thread direction and in weft thread direction.

The yarn eye is completely closed in circumferential direction about a warp yarn direction and is disposed for guiding a warp yarn.

It is further preferred that the second layer has Twaron® in the weft direction and Trevira® in the warp direction.

A float in the warp direction may have a favorable effect on the incorporation behavior in the case of a tubular implant.

In this manner both lateral surfaces of the heald are, along their respective entire length, oriented in the warp yarn direction.

In both cases, the total as well as the individual tension in the warp and weft direction can be precisely measured.

If the fabric has a woven design, make the width of the laboratory test sample, measured parallel to the warp direction, not less than one warp repeat of the design.