Übersetzung für "Rolle rückwärts" in Englisch

Kind of strange role reversal we got going on, huh?

Press the left arrow key to wind up for a backward roll.

But now, on Halo of Blood, the band is performing a backward roll.

The house fly, for example, races with two meters per second through the room, only to land with half a backward roll on the ceiling.

Although there is basically a gradient or a progression from unprepared rolls to prepared rolls from the stock reception arrangement 18 to the press 01 in the shelf blocks, a path of an unprepared roll “backwards” from the inner shelf block 24 to the outer shelf block 25, which is remote from the press 01, or to the preparation circuit 35 is also possible, in contrast to conventional systems.

Then the camera takes a measured roll backwards, shifts its view from the floor to the windows, the stucco ceiling, the wallpaper and then back to the flooring and the two windows.

To ensure that there is no backward roll, the necessary regulatory conditions must be created in the interest of end users and solution providers.

However, tapping the right side of your screen actually makes your vehicle roll rotate backwards while you’re in the air.

Now follows -though halfhearted – the "back pedalling". From 2019, changes will be discussed that provide for a noticeable reduction in tourist tax.

Which the role of reverse action tweezers is sprayed with some small parts, use it to clip spray.

This "Abissology" does not mark a retrograde movement back to myth, esoterics, or occultism—even if the voodoo cult of the Jambi in São Tomé in New Guinea is the subject of their most recent film Papagaio (2014), an exception due to its length of 43 minutes.

After Eric Martin Ain re-joined the fold Vanity/Nemesis followed that expectedly made a backward roll stylistically. Songwriting was again heavier but straighter though, lacking of the progressiveness of the past.

Exhale and roll back over your toes so that your body ends up in an inverted “V” shape, which is downward facing dog or adho mukha savasana in Sanskrit.

This “Abissology” does not mark a retrograde movement back to myth, esoterics, or occultism—even if the voodoo cult of the Jambi in São Tomé in New Guinea is the subject of their most recent film Papagaio (2014), an exception due to its length of 43 minutes.

Exhale and roll back over your toes so that your body ends up in an inverted "V" shape, which is downward facing dog or adho mukha savasana in Sanskrit. This position should feel calming and allow you to rest as you get deeper into the asana, or pose.

That hour when the fascist army sweeps back is near.

For vehicles as stable as our trikes moving backwards is a snap.

For vehicles as stable as our reecumbent trikes moving backwards is a snap.

As you roll backwards, keep your knees tucked to your chest.

But the trouble with them is, you see, that if you stop on a hill, they roll backwards.

The latter has a roller 24 which is in contact with the rear end of rear tensioning rail 8.

As soon as a trailer 17 is completely aligned with the center line of the rail car 18, i.e., when the rotatable floor 24 is latched again by locking pins 25, and when the hydraulic kingpin coupling 28 in FIGS. 10A and 10B is pressed in the first position from below against the trailer 17 with a counter-pressure of .+-.100 kg and when the motor 23 pushes the kingpin coupling 28 backwards over rollers 86, tracking in four longitudinal rails 87, the coupling will slide between the kingpin 42 of the trailer.

Depending on the volume of crop encountered at any one location as the harvester travels across the field, the spring-loaded upper front and rear rolls 82 and 58 will rise and fall as permitted by the pivot connection 16.

When the chamber 56 is empty, the front and rear runs 44 and 46 of the belts 42 respectively converge upwardly from the drive roll 26 and lower front gate roll 40 and pass closely to each other between the rolls 52 and 54, with the run 44 contacting a rear surface of the front roll 52 and with the run 46 contacting a forward surface of the rear roll 54, the chamber 56 thus being wedge-shaped as viewed from the side.

On inner sides of opposite vertical legs 38 of the slide 26 is provided horizontal axles that support front and rear rollers 40 and 42, respectively.

Specifically, beginning at a lower central location of the sidewalls 18 and proceeding counterclockwise, there are mounted a driven roll 26, a lower front roll 28, an intermediate front roll 30, an upper front roll 32, and an upper rear roll 34; and continuing counterclockwise from an upper rear location of the gate sidewalls 22 there is mounted an upper rear roll 36, a lower rear roll 38 and a lower front roll 40.

The rear roller 42 is supported on an upper surface of a rail 46, that is joined to, and extends horizontally at approximately mid-height from, a rear side of the beam 20.

The front and rear runs 44 and 46 of the belts 42 respectively converge upwardly from the drive roll 26 and lower front gate roll 40 and pass closely to each other between the rolls 52 and 54, with the run 44 contacting a rear surface of the front roll 52 and with the run 46 contacting a forward surface of the rear roll 54.

Irrespective of the movement direction of the roller body or of the rollers (forwards or backwards) thus the relief and alignment of the rollers take their course in the same manner.

Take control of the scooter forwards or backwards, do remember magnitude of you body shouldn’t be violently.

Once you've achieved a feeling of balance in basic rolling, you may progress to rolling backwards, coming forward and standing up.

As the kinetic energy during braking has been converted to other energies, the vehicle, after reaching a standstill, would roll backwards if the slope decelerating force were still present and if there were no braking moment.

The limiting value GW is defined in such a way that, when the limiting value GW is exceeded, the drive torque Mmot is so high that the vehicle at least cannot roll backward because of the drive torque Mmot.

If, therefore, it is established that, because of an automatically initiated shut-off process, it is anticipated that the motor will shortly no longer be able to operate in a self-sustaining manner (that is to say cannot start again without an appropriate starting device) and the vehicle standstill is imminent (but has not yet been reached), the brake pressure is locked in at a suitable level even before the vehicle standstill is reached and this pressure is maintained until the subsequent automatic switch-on process of the drive machine has been completed and a drive torque is provided at such a level that the vehicle can no longer roll backward or is again travelling forward.