Translation of "Geringe kraft" in English

Low visibility procedures are in force;

Initially only a very limited force is then required for raising the keel.

Accordingly, for the initial movement of the armature 6 only a minimal force is required.

The separating ability is thus prepared and requires only little force to effect.

The comparatively low weight saves energy during ascent.

Ascent: The comparatively low weight saves energy during ascent.

Only a slight, well-defined force is exerted onto the conveyor rest 3 by way of this.

This cushion can be made to be comparatively light, because of the low force.

Only a low force is therefore exerted on the elevated regions of the impression cylinder.

For this contacting movement a relatively small force is required.

This is because a solenoid generates only a low force at the start of its travel range.

This type of malt has a very low diastatic power and moderate extract values.

The disadvantage of dielectric micromechanic elements is the small force while, however, also having minimal currents.

This is manifested with measurements in the "Brabender Plasticorder" in that a small force is necessary.

This is manifested with measurements in the "Brabender Plasticorder" in that a small force is necessary.

For selecting a respective gate of the transmission only a minimal force is required.

A strong holding force is generated by the weak force of the spring 7 in the resting position.

In the case of this power wrench, the speed of the return movement is also limited by the low force of the return spring.

For the subsequent movement of the lipstick, the user only needs a relatively low force.

Only a small force of the displacement means for the actuator-plate is sufficient for good sealing.

Due to the resilience of the locking means 9 ? only a small amount of force is required to this end.

This requires only a small force and thus permits a significantly tighter airbag seam 208 .

An incomplete pressing action may have its basis, for example, in the power of the drive being too low.

At that moment the sonotrode is exerting no or only a low force on the material webs.

The helical compression spring has only a small force sufficient for displacing the auxiliary piston.

I again felt rather like an individual of but average gastronomical powers sitting down to feast alone at a table spread with provisions for a hundred.

For such purposes it is, of course, of great advantage when the release of such a switch with a magnet edge holding system requires only a low force F1 which is subsequently transformed into a much higher and automatically released action force F2.

Since the swinging cover then has a relatively small width transversely to its axis of rotation, a comparatively small force is required to swivel it up into the opening position.