Übersetzung für "Center conductor" in Deutsch

This was quickly divided in the middle and exposed shield and center conductor.

Each of the outputs 26 has a phase conductor terminal 261 and a center conductor terminal 262 .

An insulating member is preferably arranged between the outer conductor and the center conductor.

This center-conductor contact 38 is electrically connected to a center-conductor part 42 (FIG.

The center conductor is usually soldered.

Between the pipe and the center conductor of the supply voltage is on the verge of breakdown.

Should You Be Concerned With Dielectric Residue On The Center Conductor?

The individual wires are positioned in one or more layers concentrically around the litz wire center conductor.

A respective load 3 is connected between the corresponding phase conductor terminal 261 and a center conductor terminal 262 .

The diameter of first antenna elements 300 increases toward the center of hollow conductor 200 .

Recently, we received some queries about leaving dielectric residue on a center conductor.

The center conductor of a coaxial cable is connected to the electrodes on these inner faces, and the shield of the cable is connected to the electrodes on the outer faces.

In this closing process, the centering jaws 9 also move via 5, 4', 17, 18, 35 and 36 to the surface of the conductor, and thereby center the conductor 10 in the immediate area of the future cut.

The action of the centering jaws 9 should expediently not only extend to the center of the conductor 10 but to the middle from above and below (referring to FIG.

The top end of the conductor strip 3 is electrically connected to the surface 23 of the metal post 24 by a connecting means 25. The bottom end 26 is connected by a base amplifier 27 to the center conductor of a coaxial cable 28, an outer conductor of which is electrically connected to the surface 23.

Instead, residual potential increases linearly from winding to winding up to the center of the conductor band 24, and is reduced, then, linearly in the same manner to zero at the last winding.

This is continued until the receiver coil 130 ends with the terminal 138 in the center of the conductor band 24.

The terminal provided for connecting the series resonant circuit to the center conductor is situated within a smaller chamber of the pocket 28' which is formed by a step 31.

In the case of a band-stop filter according to the invention, it is not necessary, however, to bring the center conductor through the coil so that the installation is substantially simplified as compared to known devices.

The length of the connection leads 20, 21 is chosen so that an amplitude maximum ("current antinode") is formed in the center of each conductor segment 1 at the operating frequency of the R.F. electrical currents, while therebetween an amplitude minimum ("current node") is situated in the center of each connection lead 20, 21.

The connection leads 30 and 31 have a length such that at the operating frequency of the R.F. electrical currents, a "current antinode" is formed in the center of each conductor segment 1, while therebetween two "current nodes" are formed in the center of each connection lead 30, 31.

The center conductor part of the bushing is connected by soldering it to a conducting path, and also connecting the plug to the corresponding conductor of the cable.

If the ground plane is sufficiently larger than the surface segment connected to the coaxial center conductor, or if it is directly positioned above a larger conductive surface, then a radiation pattern is produced similar to that of a monopole.

However, since all the laminates have the same elasticity and the pressure force reduces radially outwards, starting from the center of the conductor, along the cutting straight line formed by the cutting edges, there is a risk of the cutting edges of the laminates located on the outside not penetrating far enough into the conductor insulation, and thus of a poor stripping result being obtained.