Übersetzung für "Tangent point" in Deutsch

Now B is computed as tangent contact point of the tangent through point E.

Smoothly means that the surface has a unique tangent at each point.

Its tangent at this point coincides with the tangent of the curve.

It would also be possible to use the term “tangent point”.

The horizontal distance between the crown of the rail and the tangent point shall be between 33,5 and 36 mm.

This property provides a way to construct the tangent at a point on the hyperbola.

If a point lies on the circle, its polar is the tangent through this point.

The fillet depth in this case is the distance of the radial through the tangent point from the run-out edge.

Thus the Mean value theorem says that given any chord of a smooth curve, we can find a point lying between the end-points of the chord such that the tangent at that point is parallel to the chord.

The left lateral edge of the plate may not be further to the left than the vertical plane parallel to the plane of symmetry of the tractor and tangent to the point where the cross section of the tractor is at its widest.

Where rain flaps are not fitted behind each wheel (see point 6.3.5), the outer valance must be unbroken between the outer edge of the rain flap to the vertical plane that is tangent to the point furthest to the front of the tyre (Figure 5a of Annex VI) of the first axle.

In other words, the tangent at the point of contact between the latch nose 18 and the latching face 7 must intersect at right angles, outside the push-in path, with a radius projecting from the pivoting point of the latch, the acute angle in the right triangle, which is formed by this point of intersection, the pivoting point of the latch and the point of contact, being larger than the angle of friction at the point of contact.

Hence w {\displaystyle w} has only point P {\displaystyle P} in common with the hyperbola and is, therefore, the tangent at point P {\displaystyle P} .

The wire D engaged by this deflector pin comes from one of the deflector rollers 8,9 meets the pin 86a at a tangent at the point T1, and partially wraps round it.

An appropriate position for seizing each fish by the respective entrainer is seen in the tangent point or the point of intersection between the path of the supply conveyor and the path of the entrainers.

The tangent length TL1 of the bottom blade 5' is the distance between the tangent point on the guardbar and the cutting edge 9'.

This contact extends along a profile which is basically perpendicular to a tangent at the point of contact.

The take-over of the fish from the supply conveyor 7 occurs by that entrainer 14 of the conveying device 13, which is lowered onto the fish at the tangent point or point of intersection between the path of the supply conveyor 7 and the circular path 15 of the entrainers 14.

When the take-over of the fish occurs above said tangent point, the fish immediately thereafter is turned about its longitudinal axis by turning the entrainer 14 so that well in time before arriving at the tail cut tool 17 the fish points radially outwardly with its tail.