Übersetzung für "Erweiterungsplatine" in Englisch

The extension board for the Ethernet network interface and TCP/IP stack is described in this guide.

The StromPi 2 expansion board is a redevelopment of the popular Joy-IT Power Solution.

With Arduino sensor expansion board can be completed and buttons of interactive works.

With sensor expansion board can be made For remote control and other interactive work.

With Arduino sensor expansion board can be made for remote control and other interactive work.

This document is for model 2 of the extension board.

With Ardu sensor expansion board can be made For remote control and other interactive work.

This expansion board is also compatible with the older ElMod central units TankModule ECO and PRO.

On the expansion board, however, something appears which we have already seen on the main board.

In our case we have decided to take the model with the 7.1 expansion card.

Furthermore, an extension motherboard 22 is located in the housing 5, which can be connected to the system bus 18 as well, and which is provided with additional plug connections for the inputs 23, for the outputs 24 and for the energy supply 25 .

The plug connections of the extension motherboard 22 are extended within the zone of the bottom wall of the housing 5 from the latter as well.

However, the extension motherboard 22 is used only if more inputs and outputs than provided on the standard I/O motherboard 17 are needed for operating the connected aggregate or the connected installation.

The connection cable is long enough to secure the expansion board slightly away from the main board.

Pin changes plus two I2C pins (SDA and SCL: next to the AREF pin, the Analog 4 and 5 copy, not the additional I2C interface), added two pins, theRESET next one is IOREF,, allowing the expansion board to adapt to on-board voltage, this pin is just told to expand the board's current on-boardvoltage (such as UNO is 5V, the power supply pin can be seen as copy, does not provide the level pull-up), and the other is after inactiveplaceholder pins.

The FRDM-33931-EVB Expansion Board is an easy-to-use circuit board that allows the user to exercise all the functions of the MC33931EK H-Bridge circuit to drive a brushed DC motor with operation between 5-28V and up to 5A.

Clamp(Paw): 55mm (maximum angle does not add the expansion board maximum opening distance 55mm, install the extension board after the maximum is 95mm)

This shield (an Expansion Board without XBee module) is a compliant solution designed to meet low-cost, low-power wireless sensor networks with special needs.

Up/downloading via a cable is still possible, via RS232 or by connecting the MP3 player to the network and/or internet with an extension board.

For this project Oscar uses a Arduino Uno and a expansion shield with LEDs and a small keyboard.

For this project Oscar uses a Arduino Uno and a expansion shield with LEDs and a small keyboard.

If the aquabus X4 extension is used together with several Calitemp sensors, each Calitemp sensor must be connected to its own aquabus connection on the extension board - several Calitemp sensors must not be connected to a single connection via splitters!

Pin changes plus two I2C pins (SDA and SCL: next to the AREF pin, the Analog 4 and 5 copy, not the additional I2C interface), addedtwo pins, the RESET next one is IOREF,, allowing the expansion board to adapt to on-board voltage, this pin is just told to expandthe board's current on-board voltage (such as UNO is 5V, the power supply pin can be seen as copy, does not provide the level pull-up), and the other is after inactive placeholder pins.

With this expansion board you can easily expand your LokPilot V4.0 or LokSound V4.0 decoder (with 21MTC interface!